Reznor WS Unit Installation Manual Bedienungsanleitung

MMMMEEEERRRRCCCCEEEERRRR,,,,PPPPAAAA UUUU...SSSS...AAAA...11116666111133337777Cod. 4050489C 07/07E 07/07INSTALLATION,OPERATION ANDMAINTENANCE MANU

STEAM CONNECTION The steam connection is performed according to the diagram shown:MAXIMUM PRESSURE: 10 BAR / 150 psi.HOT WATER CONNECTION The hot wate

CONNEXIONSELECTRIQUESAvant d’effectuer les connexions aux moteurss’assurer que l’interrupteur soit sur 0 = OFF.A proximité de l’appareil ou des appare

NETTOYAGE, ENTRETIENET PIECES DE RECHANGEAVANT DE FAIRE N’IMPORTE QUELNETTOYAGE OU ENTRETIEN ISOLERL’APPAREIL DE LA SOURCE D’ENERGIE.Seulement un pers

WS18/24WS23/33WS44/62WS60/85WS78/100WS96/120WS140/175WS190/238WS300/350MotorModel115/1/60Low SpeedPowerHpAmperRatingHigh SpeedPowerHpAmperRating0,60,9

TECHNICAL DATA with Steam for HA 12 onlyTECHNICAL DATA with Hot Water for HA 11 - HA 12The performances reflected in these tables are based on the fol

Manuale LENNOX AXIL 17-07-2007 10:11 Pagina 28

CONTENTSPurpose 2Hazard Intensity Levels / Safety Rules 4Cleaning & water treatment instructionsclosed heating system 5Unit heater maintenance &am

The big tube diameter reduces the waterpressure drops. This means more water canbe pumped with less force. It also results in avery rapid heat-up.The

HAZARD INTENSITYLEVELSThe following notations are made throughoutthis manual. Each denotes a specific level ofhazard intensity.1- Danger: Failure to c

Ne pas détacher les étiquettes de sécurité;au cas où elles sont illisibles, en demander lasubstitution.Si l’aérotherme doit être démonté, user desgant

ENTRETIEN AEROTHERMEET TRAITEMENTDE L’EAUTout système à vapeur ou à eau chaude exigeun Programme de Traitement de l'eau appropriéavec des analyse

ModelApproximate Weight Water contentLiter U.S. gallonlbKgNoise leveldb (A)at 17 feetat the rear.low speed high speedWS18/24WS23/33WS44/62WS60/85WS78/

DENOMINATION A INCHREZNOR HYDRONIC UNIT HEATER SHW 18/24" " " " SHW 23/33" " " " SHW 44/62" " "

C-Suspended from the ceiling for vertical downair flow as follows:C1 - Determine the installation height,C2 - Attach the suspension plates (provided)