Reznor R6GP Option - Installation - Bottom Power Entry Bedienungsanleitung PDF herunterladen (Seite 4)

7. On the left side of the unit control panel, behind

the low-voltage connection box, remove the 1”

diameter Heyco bushing from the base of the control

panel and install the remaining ¾” diameter FMC

connector.

8. Install the two insulator sleeves in the ends of the

¾” diameter ﬂ exible metal conduit and then install

the conduit fully into the connectors and secure it

in place.

9. Install the 7/8” diameter star bushing into the bottom

hole on the bottom power entry box and one of the

1-1/4” diameter FMC connectors in the remaining

(top,front) hole of the bottom power entry box.

Figure 4.

Figure 6.

Figure 5.

10. On the base of the Blower compartment / Condenser

section external divider panel, remove the plastic

button plug and open up the slit in the insulation.

Figure 7.

11. Install the remaining 1-1/4” diameter FMC

connector.

12. Insert the two 1-1/4” insulator sleeves into the ends

of the 1-1/4” ﬂ exible metal conduit and install the

conduit into the two connectors. Secure the conduit

in place.

1 2 3 4 5 6 7 8

Keine Kommentare

Reznor R6GP Option - Installation - Bottom Power Entry Bedienungsanleitung Seite 4